在线超碰av,天天操天天摸天天射,免费的爱爱视频,情侣av在线,一级片中文字幕,2022国产毛片大全,精品亚洲大全

140CPS11410
可以將記錄道設置為以下模式。
•寫入模式第6.2節
•固定模式第6.2節
•大/小保持模式第6.3節
•滾動平均模式第6.4節
•計算模式第6.5節至第6.9節
下面解釋了每種模式。
寫入模式
波形數據在掃描期間寫入。
當記錄道設置為寫入模式時，在測量過程中寫入波形數據，
并更新數據。測量中使用的記錄道通常設置為寫入
模式數據區側面的跟蹤顯示變?yōu)?ldquo;寫入”
修復模式
修復數據；不寫入波形數據。
當記錄道設置為固定模式時，即使在以下情況下，其波形數據也不會被覆蓋
進行測量。因此，屏幕上的波形不會被覆蓋。如果
要修復記錄道的波形數據，請將記錄道設置為修復模式。跟蹤顯示
在數據區域的一側更改為“修復”

Traces can be set to the following modes. • WRITE mode Section 6.2 • FIX mode Section 6.2 • MAX/MIN HOLD mode Section 6.3 • ROLL AVG mode Section 6.4 • CALCULATE mode Section 6.5 to Section 6.9 The following explains each of the modes. WRITE Mode Waveform data are written during sweeping. When a trace is set to WRITE mode, waveform data are written during measurement, and the data are updated. Traces used in measurements are normally set to WRITE mode. The trace display at the side of the data area changes to “WRITE.” FIX Mode Fixes the data; does not write waveform data. When a trace is set to FIX mode, its waveform data are not overwritten even when measurement is performed. Therefore, the waveform on the screen is not overwritten. If you want to fix the waveform data of a trace, set the trace to FIX mode. The trace display at the side of the data area changes to “FIX.”