在线超碰av,天天操天天摸天天射,免费的爱爱视频,情侣av在线,一级片中文字幕,2022国产毛片大全,精品亚洲大全

140AVI03000
寫入每次掃描波形數據的大/小值。
當記錄道設置為大/小保持模式時，每次執行掃描時，數據
在各個測量點與先前的測量進行比較，并且
寫入較高電平（大保持）或較低電平（小保持）的測量值。
如果要測量變化的波形的大值或小值
每次執行掃描時，將要測量的軌跡設置為大/小保持
模式并執行重復掃描。
數據區側面的跟蹤顯示顯示為“大保持”或“小保持”。
請注意，當顯示波形時，噪聲屏蔽軟鍵設置適用，并且
檢測到大值或小值時不受影響。
滾動平均模式（滾動平均模式）
寫入每次掃描期間波形數據的滾動平均值。
當軌跡設置為滾動平均模式時，每次進行測量時，滾動
計算當前測量值和過去測量值的平均值
更新測量數據。平均數設置在2到
數據區側面的軌跡顯示變?yōu)?ldquo;ROLL AVG”

Writes the maximum/minimum values of the waveform data for each sweep. When a trace is set to MAX/MIN HOLD mode, each time a sweep is performed, the data at the individual measurement points are compared with prior measurements, and the measurement with the higher level (MAX HOLD) or lower level (MIN HOLD) is written. If you want to measure the maximum or minimum value of a waveform which changes each time a sweep is performed, set the trace you want to measure to MAX/MIN HOLD mode and perform REPEAT sweeping. The trace display at the side of the data area appears as “MAX HOLD” or “MIN HOLD”. Note that the NOISE MASK soft key setting applies when a waveform is displayed, and is not affected when a maximum or minimum value is detected. ROLL AVG Mode (Rolling Average Mode) Writes the rolling average values of the waveform data during each sweep. When a trace is set to ROLL AVG mode, each time measurement is performed the rolling average of the current measurement and past measurements is calculated, and the measurement data are updated. The number of averagings is set in the range of 2 to 100. The trace display at the side of the data area changes to “ROLL AVG”