在线超碰av,天天操天天摸天天射,免费的爱爱视频,情侣av在线,一级片中文字幕,2022国产毛片大全,精品亚洲大全

MAC112C-0-HD-3-?C/130-B-1/S021
電源端子排的電氣連接下面的電氣連接說明首先根據電源端子排的編號（例如X1、X2等）進行分組，然后根據功能進行分組。串行接口X1串行接口通常用于啟動操作和維修過程中的編程、參數化和診斷。它可以作為RS 232或RS 485操作。在啟動操作和維修過程中，需要RS-232接口進行編程、參數化和診斷。當通過RS-485將驅動器地址設置為操作要求時，也會使用它。使用RS 232，在使用DriveTop啟動程序時，一次只能參數化一個驅動器。DKC電纜：IKS 0101 AP0224。fh5 TxD RxD GND DTR DSR RTS CTS 3 2 5 4 6 7 8 DKC 1）PC上的外部屏蔽必須連接到單元機箱。大15米1）TxD RxD GND DTR DSR RTS CTS 2 3 7 20 6 4 5 1）TxD RxD 0 V 2 1 3 6 5 4 X1電纜：IKS 0102 PC帶9針D微型連接器TxD RxD 0 V 2 1 3 6 4 X1大15米PC帶25針D微型連接器

Electrical connection to the supply terminal strips The description of the electrical connections below are first grouped according to numbers of the supply terminal strips (e.g. X1, X2 etc.) and then according to the functions. Serial interface X1 The serial interface is generally used for programming, parameterization and diagnoses during startup operation and service procedures. It can be alternatively operated as a RS 232 or RS 485. The RS-232 interface is needed for programming, parameterizing and diagnosis during startup operation and service procedures. It is also used when setting the drive addresses as a requirement for operations via RS-485. With the RS 232, it is possible to parameterize only one drive at a time when using the DriveTop startup program. DKC cable: IKS 0101 AP0224.fh5 TxD RxD GND DTR DSR RTS CTS 3 2 5 4 6 7 8 DKC 1) External shield on PC must be attached to unit chassis. max. 15 meters 1) TxD RxD GND DTR DSR RTS CTS 2 3 7 20 6 4 5 1) TxD RxD 0 V 2 1 3 6 5 4 X1 cable: IKS 0102 PC with 9-pin D-subminiature connector TxD RxD 0 V 2 1 3 6 5 4 X1 max. 15 meters PC with 25-pin D-subminiatureconnector