在线超碰av,天天操天天摸天天射,免费的爱爱视频,情侣av在线,一级片中文字幕,2022国产毛片大全,精品亚洲大全

KDS1.1-150-300-W1-220/S102
僅適用于電壓超過50伏的設備和驅動部件。
接觸電壓大于50的部件
電壓可能很危險。在以下情況下，某些部件處于危險電壓下
操作電氣設備。
危險
高壓！
危及生命或人身傷害的風險！
⇒ 遵守一般施工和安全規定
在電氣裝置上工作時。
⇒ 接通電源前，確保接地
電線連接至所有電氣裝置
根據連接圖。
⇒ 如果
接地線未連接到
適當?shù)亩俗?，即使是短暫測量或
測驗。
⇒ 斷開設備與電源線的連接
或開始工作前的電壓源。保護
重合閘設備。
⇒ 關閉電源后等待5分鐘，讓電容器放電，然后再使用設備。
開始工作前測量電容器的電壓，以消除以下危險：
觸摸組件。
⇒ 電源接通時，切勿觸摸部件的電氣連接點。
⇒ 在打開設備之前，請蓋好帶電部件，以免接觸到它們。提供的蓋子
操作前必須安裝設備
防止與帶電部件接觸的設備。這個
設備只能在帶有防電擊保護罩的情況下操作。
⇒ GFCI保護裝置（接地故障斷路器）不能用于交流驅動器！保護
必須通過其他方式確保防止間接接觸
指，例如，根據相關標準使用過電流保護裝置。
歐洲國家：符合EN
50178/1994，第5.3.2.3節
⇒ 用于安裝設備的間接保護
必須使用外部外殼確保接觸，
例如控制柜。歐洲國家：根據EN 50178/1994第5.3.2.3節

Only relevant for devices and drive components with voltages exceeding 50 volts. Coming into contact with components carrying voltages greater than 50 volts can be dangerous. Certain parts are under dangerous voltage when operating electrical devices. DANGER High Voltage! Danger to life or risk of bodily injury! ⇒ Follow general construction and safety regulations when working on electrical installations. ⇒ Before switching on power, be sure that the ground wire is permanently connected to all electrical units according to the connection diagram. ⇒ At no time may electrical equipment be operated if the ground wire is not permanently connected to the proper terminals, even for brief measurements or tests. ⇒ Disconnect the equipment from the power supply line or the voltage source before beginning work. Secure equipment from reclosure. ⇒ Wait 5 minutes after switching off power to allow capacitors to discharge before using the equipment. Measure the voltage of the capacitors before beginning work in order to eliminate dangers arising from touching components. ⇒ Never touch the electrical connection points of a component while the power is turned on. ⇒ Cover live parts properly before switching the equipment on so they cannot be touched. Covers provided with the equipment must be installed before operating the equipment to prevent contact with live parts. The equipment may only be operated with the covers designed for shock-hazard protection. ⇒ A GFCI protective device (ground fault circuit interrupter) cannot be used for AC drives! Protection against indirect contact must be ensured by other means, for example, by using an overcurrent protection device in accordance with relevant standards. European countries: in accordance with EN 50178/1994, section 5.3.2.3 ⇒ For installation equipment protection against indirect contact must be ensured using an external housing, such as a control cabinet. European countries: in accordance with EN 50178/1994, section 5.3.2.3