在线超碰av,天天操天天摸天天射,免费的爱爱视频,情侣av在线,一级片中文字幕,2022国产毛片大全,精品亚洲大全

MVME5110-2261
通用可讀跳線標頭（J22）標頭J22提供八條可讀跳線。這些跳線可以作為MCchip LCSR（本地控制/狀態(tài)寄存器）中的寄存器讀?。‵FF4202D美元）。安裝跳線時，位值讀取為零，拆下跳線時，位值讀取為1。如果安裝了MVMEBUG固件，則四條跳線可由用戶定義（引腳1-2、3-4、5-6、7-8）。如果未安裝MVMEBUG固件，則七條跳線可由用戶定義（引腳1-2、3-4、5-6、7-8、11-12、13-14、15-16）。注：引腳9-10（GPIO3）保留用于選擇閃存映射（已安裝跳線）或EPROM內(nèi)存映射（已移除跳線）。它們不可由用戶定義。MVME出廠時J22設(shè)置為全零（所有引腳上的跳線）。J22 15 GPIO7 GPIO6 GPIO5 GPIO1 GPIO4 GPIO3 GPIO2 1 2 GPIO0 16選擇的EPROM（工廠配置）用戶可定義用戶可定義用戶可定義參考BUG手冊用戶可定義IN=閃存；OUT=EPROM參考BUG手冊參考BUG手冊BUG安裝用戶可定義用戶可定義用戶可定義用戶可定義IN=閃存；OUT=EPROM用戶可定義用戶可定義

General-Purpose Readable Jumpers Header (J22) Header J22 provides eight readable jumpers. These jumpers can be read as a register (at $FFF4202D) in the MCchip LCSR (local control/status register). The bit values are read as a zero when the jumper is installed, and as a one when the jumper is removed. If the MVMEBUG firmware is installed, four jumpers are user-definable (pins 1-2, 3-4, 5-6, 7-8). If the MVMEBUG firmware is not installed, seven jumpers are user-definable (pins 1-2, 3-4, 5-6, 7-8, 11-12, 13-14, 15-16). Note Pins 9-10 (GPIO3) are reserved to select either the Flash memory map (jumper installed) or the EPROM memory map (jumper removed). They are not user-definable. The MVME is shipped from the factory with J22 set to all zeros (jumpers on all pins). J22 15 GPIO7 GPIO6 GPIO5 GPIO1 GPIO4 GPIO3 GPIO2 1 2 GPIO0 16 EPROMs Selected (factory configuration) USER-DEFINABLE USER-DEFINABLE USER-DEFINABLE REFER TO BUG MANUAL USER-DEFINABLE IN=FLASH; OUT=EPROM REFER TO BUG MANUAL REFER TO BUG MANUAL BUG INSTALLED USER-DEFINABLE USER-DEFINABLE USER-DEFINABLE USER-DEFINABLE USER-DEFINABLE IN=FLASH; OUT=EPROM USER-DEFINABLE USER-DEFINABLE